Q&A Forums

temperature settings Post New Topic | Post Reply

Author Comments
ben wright
Posted: Oct 13, 2008 02:38 AM
temperature settings
Can I get some insight into setting up hose heat and preheat
temperature settings.I'm using 2# RTC cc foam.A new Reactor
H-40 machine and a d gun.The manufacture calls for 110-120 A Side,110-130 B side.

Do I set at lowest temp and adjust as I go to get the best pattern
and performance.Do I change with the speed of chemical output?
clint moore
Posted: Oct 13, 2008 10:42 AM
Here is a good starting point, set your temperatures at 120 across the board,pressure at 1200. Now because your B side material is thicker run it about 10 degrees higher. bring your hose heat up to target temp. before turning on preheaters. Hose takes about 30 -45 min. to heat ,preheaters take 15-30 seconds.Test spray to see how your foam looks and make adjustments accordingly.Colder ambient temperatures require more heat,hotter require less.Some will disagree,just my two cents.

You need to login to reply to this topic. Please click here to login.